VIEWSONIC PJ1165 - Manual (Page 17)

ViewSonic PJ1165 16
Operating
Selecting An Input Signal
1 Select an input signal.
Using the INPUT dial
Turn the INPUT dial of the projector.
Turning the dial cycles through the input ports as
shown below. Select the signal you wish to
project.
Using SEARCH button
Press the SEARCH button of the projector or the
remote control.
Pressing the button automatically cycles through
input ports and displays the picture of retrieved
signal.
memo
If no signal is found or the projector is
unstable to find an input signal at any of its ports,
it will turn to the state it was in prior to the search.
Using RGB button
Press the RGB button of the remote control.
Pressing the button toggles between the RGB
ports as shown below Select the signal you wish
to project.
Using VIDEO button
Press the VIDEO button of the remote control.
Pressing the button toggles between the VIDEO
ports as shown below Select the signal you wish
to project.
2 Use the ZOOM buttons to adjust the screen size.
3 Use the FOCUS buttons to adjust the focus.
SEARCH button
INPUT dial
VIDEO button
RGB button
SEARCH button
ZOOM
buttons
FOCUS
buttons