VIEWSONIC PJ1165 - Manual (Page 16)

ViewSonic PJ1165 15
Power On/Off
NOTE
• Turn the power on/off in right order. Please power on the projector before the connected
devices. Power off the projector after the connected devices.
Turning On The Power
1 Remove the lens cap.
2 Set the power switch to [ | ] (On).
The STANDBY/ON indicator will light to solid
orange.
3 Press the STANDBY/ON button.
The projector lamp will light up and the
STANDBY/ON indicator will begin blinking green.
When the power is completely on, the indicator
will stop blinking and light green.
4 Select an input signal according to the section
“Selecting An Input Sign al” of the following page.
Turning Off The Power
1 Press the STANDBY/ON button.
The message “Power off?” will appear on the
screen for approximately 5 seconds.
2 Press the STANDBY/ON button again while
“Power off?” message is visible.
The projector lamp will go off, and the STANDBY/
ON indicator will begin blinking orange. The
STANBY/ON indicator will stop blinking and light
to solid orange when the lamp cooling is complete.
3 Set the power switch to [O] (Off).
The STANDBY/ON indicator will go off.
4 Attach the lens cap.
WARNING
• When the power is On, a strong light emitted. Do not look into the lens or vents of the
projector.
STANDBY/ON button / indicator
Power switch (On position)
STANDBY/ON
button
Power switch (Off position)
STANDBY/ON
button
STANDBY/ON button / indicator