VIEWSONIC PJL6233 - Manual (Page 56)

Setting
7LPHOHIWEHIRUH/DPSLVRII
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready ............... When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition,
the projection lamp will be turned on if
the input signal is reconnected or any
button on the top control or remote
control is pressed.
Shut down ....... When the lamp has been fully cooled
down, the power will be turned off.
Off .................... Power management function is off.
Timer ................ If the input signal is interrupted and
no button is pressed for more than
VHFRQGVWKHWLPHUGLVSOD\ZLWK
No signal appears. It starts the
countdown until the lamp is turned off.
Use the Point
Ÿź buttons to set the
7LPHUaPLQ
3Note:
Factory default is Ready: 5 min.
Network
English
Blue
On Direct on
On
Off
Off
Off
Computer 2
►
►
1/2
Standby mode
Off
5 Timer 5 Min
When this function is set to On, the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.
3Note:
Be sure to turn off the projector properly (see “Turning Off
WKH3URMHFWRU´RQSDJH,IWKHSURMHFWRULVWXUQHGRIILQ
the incorrect sequence, the Direct on function will not
work properly.
Power management
Direct on