VIEWSONIC PJL6233 - Manual (Page 34)

Computer Input
PC System Menu
PC System Menu
Computer System Selection
7KLVSURMHFWRUDXWRPDWLFDOO\WXQHVWRYDULRXVW\SHVRIFRPSXWHUVZLWKLWV0XOWLVFDQV\VWHPDQG$XWR3&
Adjustment. If a computer is selected as a signal source, this projector automatically detects the signal format
and tunes to project a proper image without any additional settings. (Signal formats provided in this projector are
VKRZQRQSDJH
One of the following messages may appear when:
:KHQWKHSURMHFWRUFDQQRWUHFRJQL]HWKH
connected signal conforming to the provided
PC systems, Auto is displayed on the System
0HQXER[DQGWKH$XWR3&$GMXVWPHQWIXQFWLRQ
works to display proper images. If the image is
not projected properly, a manual adjustment is
UHTXLUHGSS
There is no signal input from the computer.
Check the connection between your computer
and the projector. (See “Troubleshooting” on
S
Auto
-----
The preset system is manually adjusted in the
PC adjust Menu. The adjusted data can be
stored in Mode 1–10
SS
Mode 1
PC Systems provided in this projector is chosen.
The projector chooses a proper system provided
in the projector and displays it.
SVGA 1
0RGHDQG69*$DUHH[DPSOHV
1
2
PC system can also be selected manually.
Selecting Computer System Manually
3UHVVWKH0(18EXWWRQWRGLVSOD\WKH2Q6FUHHQ
Menu. Use the Point
Ÿź buttons to select Input and
then press the Point Ź RUWKH6(/(&7EXWWRQ
Use the Point Ÿź buttons to select System and then
press the Point Ź RUWKH6(/(&7EXWWRQ
Use the Point Ÿź buttons to select the desired system
DQGWKHQSUHVVWKH6(/(&7EXWWRQ
3
►
►
Computer 1 RGB
Computer 2 RGB
Video
System XGA 1
The PC System Menu
Selected system is
displayed.
6\VWHPVLQWKLVGLDORJER[
can be selected.
&XVWRPL]HGMode
(1–10) set in the
PC adjust Menu
SS