VIEWSONIC PJL6233 - Manual (Page 24)

7KHSUHSDUDWLRQGLVSOD\ZLOOGLVDSSHDUDIWHU
seconds.
6HHSDJHIRU/DPSFRQWUROVWDWXV
Turning On the Projector
Connect the projector’s AC power cord into an AC
outlet. The POWER indicator lights red. Open the lens
FDSVHHSDJHV
3UHVVWKH2167$1'%on the remote control. The POWER indicator lights
green and the cooling fans start to operate. The
preparation display appears on the screen.
2
3
1 Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
Selected Input Source and Lamp Control
3 Note:
7KH)LOWHUZDUQLQJDQG/DPSUHSODFHPHQW
icons may appear on the screen
depending on the usage state of the
projector.
Basic Operation
/DPSFRQWUROVWDWXV
Video
4 $IWHUDERXWVHFRQGVWKHLQSXWVRXUFHWKDWZDV
selected the last time and the lamp control status icon
VHHSDJHDSSHDURQWKHVFUHHQ
3 Note:
‡:KHQWKH/RJRVHOHFWIXQFWLRQLVVHWWROff, the logo will
QRWEHVKRZQRQWKHVFUHHQS
‡:KHQOff is selected in the Display function, the
preparation display will not be shown on the screen
S
‡:KHQWKH,QSXW6HDUFKIXQFWLRQLVVHWWROn2, the input
VLJQDOZLOOEHVHDUFKHGDXWRPDWLFDOO\S
‡:KHQOff is selected in the Display function, the Video/
PC selection window and the input signal guidance
ZLQGRZDUHQRWVKRZQRQWKHVFUHHQS
5 If there is no signal input when start on the projector,
or the current signal is missed while operating the
projector, the Video/PC selection window will be
displayed on the screen, please move the pointer to
input source desired by pressing the Point
Ÿź buttons
DQGSUHVVWKH6(/(&7EXWWRQ$QGWKHQIROORZWKH
input signal guidance window to correct the signal and
connection.
If the projector is locked with a PIN code, PIN code input
GLDORJER[ZLOODSSHDU(QWHUWKH3,1FRGHDVLQVWUXFWHG
RQWKHQH[WSDJH
Video / PC selection window
Input signal guidance window
Video / PC selection window
Input signal guidance window
Project Video
Project Computer
Cancel
Project Video
Project Video
Project Computer
Cancel
Project Computer
No signal
Current Input setting:Video
Is signal processed correctly?
Is cable connected properly?
No signal
Current Input setting:RGB
Is signal processed correctly?
Is cable connected properly?