Vanguard Managed Solutions Vanguard 6500 PLUS - Manual (Page 28)

2-20 Installation
Installing Standalone Units
Installing Standalone Units
Introduction This section explains how to set up a 6500 PLUS standalone enclosure. When you
receive the enclosure, it already contains a 6505 PLUS , 6507 PLUS , or 6525 PLUS card.
Unpacking Before you unpack the 6500 standalone enclosure, check the outside of the package.
If the package is damaged, contact the shipping agent.
Site Preparation Install the standalone enclosure in a clean location free from shock, vibration, and
extremes of temperature and humidity. The site must meet the physical and
environmental requirements listed in Appendix B, Specifications. Be sure there is at
least 12 inches (30.5 cm) clearance at the rear of the unit for interface cabling and
ventilation.
Caution
Be sure that the standalone enclosure's air vents are uncovered. If the vents are
covered, the unit could overheat.
Example of
Standalone
Enclosure Figure 2-1 shows a standalone enclosure.
Figure 2-1. Standalone Enclosure
Power Supply
Door
Backplane
Screw
Clear Plastic Insulator
Processor Card with
6505, 6507, or
6525 ID Module