Vanguard Managed Solutions Vanguard 6500 PLUS - Manual (Page 27)

Installation 2-19
Chapter 2
Installation
Overview
Introduction This chapter contains installation procedures for:
• 6500 PLUS Series standalone enclosures
• 6500 PLUS processor card components
• Software options
A description of the processor front panel LED power-up sequence and soft-
ware upgrade procedures are also included.
This chapter also contains instructions for installing TRIM cards in Modulus
enclosures. For general information on setting up Modulus 8/18 enclosures and
inserting 6500
PLUS cards into the enclosures, refer to the Modulus Planning and
Installation Guide . For Modulus 9/21 enclosures, see the Modulus 9 and 21
Installation and Operation Guide.
Warning etc. The following special notices apply to all equipment handling procedures in this
chapter:
Be sure a power outlet is near the equipment and easily accessible.
Warning
Only trained, qualified technicians should perform the installation and replacement
procedures in this chapter.
Caution
Ports that are capable of connecting to other apparatus are defined as SELV. To
ensure conformity with EN60950 — ensure that these ports are only connected to
ports of the same type on other apparatus.
6500 PLUS cards, DIMs, SIMMs, and FLASH modules are sensitive to static
discharge, which can damage components. Use proper handling and grounding
precautions whenever you handle a 6500
PLUS card.