Toshiba M30 - Manual (Page 211)

G-3
A
PPENDIX
G
*1 Factory-set default channels
*2 Refer to the sheet Approved Countries/Regions for use for the countries/regions
that in which these channels can be used.
When installing Wireless LAN Cards, the channel configuration is managed as
follows:
❖ ❖ ❖ ❖ ❖ For wireless clients that operate in a Wireless LAN Infrastructure, the Wireless
LAN Card will automatically start operation at the channel identified by the
Wireless LAN Access Point, When roaming between different access points
the station can dynamically switch to another channel if required.
❖ ❖ ❖ ❖ ❖ For Wireless LAN Cards installed in Wireless clients that operating in a peer-
to-peer mode, the card will use the default channel 10.
❖ ❖ ❖ ❖ ❖ In a Wireless LAN Access Point, the Wireless LAN card will use the factory-
set default channel (printed in bold), unless the LAN Administrator selected a
different channel when configuring the Wireless LAN Access Point device.
Wireless IEEE 802.11 Channels Sets (Revision A)
Channel ID Frequency Range 5150-5850 MHz Note
36 5180
40 5200
44 5220
48 5240
52 5260
56 5280
60 5300
64 5320
149 5745
153 5765
157 5785
161 5805
Appendix G