Toshiba M30 - Manual (Page 170)

User's Manual
T
ROUBLESHOOTING
9-22
A CONNECT display Check the error control setting in your
is quickly replaced by communications application.
NO CARRIER
You can also use the AT\N command. Refer to
Appendix C,
AT Commands .
Character display In data transmission, make sure the parity bit
becomes garbled and stop bit settings correspond with those
during a of the remote computer.
communication
Check the flow control and communication
protocol.
You cannot receive Check the rings before auto answer setting in
an incoming call your communications application.
You can also use the ATS0 command. Refer to
Appendix D,
S-registers .
If problems persist, contact your dealer.
LAN
Problem Procedure
Cannot access LAN Check for a firm cable connection between the
LAN jack and the LAN HUB.
Wake-up on LAN Make sure the universal AC adaptor is con-
does not work nected. The Wake-up on LAN function consumes
power even when the system is off.
If problems persist, consult your LAN administra-
tor.