Changing the resolution, Parallel printer, Changing the resolution -11 – Toshiba M30 User Manual
Page 145: Parallel printer -11
8-11
O
PTIONAL
D
EVICES
NOTE: If a television is connected to the computer, set the TV type in
Display Properties. Follow the steps below.
a.
Click
start
and click
Control Panel
.
b.
Double-click the
Display
icon to open the Display Properties
window.
c. Click the
Settings
tab and click the
Advanced
button.
d.
Click the
nView Display Mode
tab, click
Device Settings
and
click
Select Output Device
.
e. Select
Advanced
and select
TV
in the
Device Selection
window.
f.
Select the
Format
box and select the format that your TV supports.
Changing the resolution
After you connect a TV (NTSC), follow the steps below to set the Display resolu-
tion to 640 x 480.
1.
Open
Display properties
and select the
Settings
tab.
2.
Select
Advanced
.
3.
Select the
Adapter
tab, then select
List All Modes...
.
4.
Select
640 by 480, High Color (16 bit), 60 Hertz
.
Parallel printer
You can connect any standard Centronics-compatible parallel printer to your
computer. All you need is an IBM PC™ parallel printer cable. Your dealer can
supply one or you can purchase one at most computer stores.
The cable’s connectors are designed so that it is impossible for you to connect
them incorrectly. To connect a printer, follow these steps:
1.
Turn off the computer.
2. Insert one end of the cable into the computer’s parallel port.
3. Tighten the screws that fasten the cable connector to the computer’s parallel
port.
4. Insert the other end of the cable into the printer’s parallel connector.
5. Fasten the connector to the printer with the clips on the parallel port.
6. Turn on the printer.
Parallel printer