Using the command line interface (cli), Command line interface, Getting started – TANDBERG D14049.01 User Manual
Page 17
7
D 14049.01
07.2007
7
System Administrator Access
In this Administrator Guide, instructions for performing a
task using the command line interface are shown in the
format:
xConfiguration CommandName
Typing the given command into the CLI will return a full list of
options and parameters available for that command.
Typing a
?
after the command will return information about the
purpose of that command or group of commands.
•
Using the Command Line Interface (CLI)
The command line interface is available over SSH, Telnet and
through the serial port.
To use the command line interface:
Start a SSH or Telnet session.
Enter the IP address or FQDN of the VCS.
Login with a username of
admin
and your system password.
Commands are divided into different groups according to their
function:
xStatus
These commands return information
about the current status of the system.
Information such as current calls and
registrations is available through this
command group.
xConfiguration These commands allow you to add and
edit single items of data such as IP
address and zones.
xCommand
These commands allow you to add and
configure items and obtain information.
xHistory
These commands provide historical
information about calls and registrations.
xFeedback
These commands provide information
about events as they happen, such as
calls and registrations.
See the
Appendix for a full description of
commands available on the VCS.
.
.
3.
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Getting Started