Text goes here, Command reference - xconfiguration – TANDBERG D14049.01 User Manual
Page 142
D 14049.01
07.2007
4
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Command Reference - xConfiguration
Zones
cont...
LocalZone
cont...
SubZone [..00]
cont...
Bandwidth
cont....
Total
Mode:
Determines whether this subzone has a limit on the total bandwidth of calls being
used by its endpoints at any one time.
None
: no bandwidth will be available.
Limited
: there will be a limit on the bandwidth.
Unlimited
: there will be no limit on the bandwidth.
Limit: <..00000000>
(applies only if Mode is set to Limited)
Sets the total bandwidth limit (in kbps) of this subzone.
Name:
Assigns a name to this subzone.
Subnet [..5]
IP
Address:
Specifies an IP address used (in conjunction with the IP Prefix Length) to identify a subnet to be
assigned to this subzone.
PrefixLength: <0..128>
Specifies the number of bits of the Subnet IP address which must match for an IP address to
belong in this subzone.
Traversal
H33
Assent
Mode:
Determines whether or not H.323 calls using Assent mode for firewall traversal will
be allowed. Applies to traversal-enabled endpoints registered directly with the VCS.
On
: calls using Assent mode will be allowed.
Off
: calls using Assent mode will not be allowed.
H4608
Mode:
Determines whether or not H.323 calls using H.460.18 mode for firewall traversal
will be allowed. Applies to traversal-enabled endpoints registered directly with the
VCS.
On
: calls using H.460.18 mode will be allowed.
Off
: calls using H.460.18 mode will not be allowed.
H4609
Demultiplexing
Mode:
Determines whether the VCS will operate in Demultiplexing
mode for calls from traversal-enabled endpoints registered
directly with it.
On
: allows use of the same two ports for all calls.
Off
: Each call will use a separate pair of ports for media.