Xcommand subzoneadd, Text goes here, Command reference - xcommand – TANDBERG D14049.01 User Manual
Page 154
D 14049.01
07.2007
54
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Command Reference - xCommand
xCommand
Description
Parameters
SubZoneAdd
Adds and configures a new subzone.
SubZoneName
(r)
:
Assigns a name to this subzone.
Address:
Specifies an IP address used (in conjunction with the IP Prefix Length) to identify a subnet to be assigned to this subzone.
PrefixLength: <0..128>
Specifies the number of bits of the Subnet IP address which must match for an IP address to belong in this subzone.
TotalMode:
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any one time.
Total: <..00000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if Mode is set to Limited).
PerCallInterMode:
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
PerCallInter: <..00000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set
to Limited).
PerCallIntraMode:
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
PerCallIntra: <..00000000>
Specifies the bandwidth limit (in kbps) on any one call between two endpoints within this subzone.
SubZoneDelete
Deletes a subzone.
SubZoneId
(r)
: <..00>
The index of the subzone to be deleted.