TANDBERG GW Dataport Command Interface D13202 - Manual (Page 5)

TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 5
2.2. Configuring The Dataport From The Web Interface
Click on System Configuration tab and then the Dataport button. The Dataport can be
configured by setting baudrate, parity, databits and stopbits.
2.3. Troubleshooting
If communication cannot be established between the PC/terminal and the TANDBERG GW’s
Dataport the following should be checked:
• Verify that the serial cable is a straight through 9-pin to 9-pin cable
• Confirm that the configuration of the PC/terminal’s serial RS-232 port is identical to
the configuration of the TANDBERG GW RS-232 port.
• Verify that the PC/terminal’s serial RS-232 port is working properly by connecting it
back-to-back to another PC/terminal and send characters in both directions
1
.
1 It requires a null-modem cable to perform this test