TANDBERG GW Dataport Command Interface D13202 - Manual (Page 23)

TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 23
chanstat Used to list channel status information for the PRI interface.
chanstat [pri interface] [channel]
Status format:
chanstat
:
---
Parameters:
• PRI interface: a/b/c/d. Letters identifying the different PRI interfaces.
o a: PRI interface 1
o b: PRI interface 2
o c: PRI interface 3
o d: PRI interface 4
• channel: 1..31(E1-PRI), 1..24(T1-PRI)
• channel-status: idle / answering / calling / connect / disconnecting /
disconnected
• calling-number: Remote number. (“” if no valid number)
• causeLoc: Standard ISDN cause location value (255 indicates no valid
code).
• chanCause: Standard ISDN cause value (255 indicates no valid code).
• connection-time(sec): Connection time in seconds.
Example of chanstat feedback:
*S chanstat a 28 connect 123456789 255:255 334Sec
encstatus Returns encryption status for the active calls.
encstatus [callid]
Status format:
encstatus
---
Parameters:
• callid: 1..16/32. Identifier referring to a call.
• incomstat: off/idle/des/aes128/negotiate
• outgoingstat: off/idle/des/aes128/negotiate
• check-code: Key that can be manually presented by the participants to
confirm secure connection
Example of encstatus feedback:
*S encstatus 11 des des 9FE389C8F664F3F5
Lists the active terminals in a GW call.
gwcalls [gwid]
Status format:
gwcalls termnumber>
---
Parameters:
• gwid: 1..16. Identifier referring to a GW call.
• isdn callid: The call id of the ISDN terminal
• isdn termnumber: The number of the ISDN terminal