TANDBERG GW Dataport Command Interface D13202 User Manual
Page 13

TANDBERG GW
Dataport Command Interface User Guide
D13202 Rev 01
13
---
parameters:
•
profile number: p1/p2/p3/p4/p5/p6. The GW can hold as many as six
profiles (p1, p2 and p3 are predefined and can not be changed).
•
call prefix: The prefix number for this profile.
•
profile name: The profile’s name. Textstring of maximum 8 characters.
•
network: auto/h320/h323
NOTE! This parameter will be overridden by the GW, ref. command
calltransfer.
Example of netprofile feedback:
*P netprofile p1 "" Auto auto
*P netprofile p2 "" ISDN h320
*P netprofile p3 "" H323 h323
*P netprofile p4 0 Ext auto
*P netprofile p5 1 test auto
*P netprofile p6 2 test2 auto
pardial
Sets parallel dial mode for BONDING calls. If pardial is set to off the GW will set-
up BONDING calls by dialling all channels in a sequential manner, i.e. the system
will wait for a connection on the current channel before attempting to connect the
next.
pardial
Example of pardial feedback:
*P pardial off
pricable
Sets PRI interface cable lengths.
pricable [PRI interface]
parameters:
•
PRI interface: a/b/c/d. Letters identifying the different PRI interfaces. If
this parameter is omitted the given value is set for all interfaces.
o
a: PRI interface 1
o
b: PRI interface 2
o
c: PRI interface 3
o
d: PRI interface 4
•
cablelength: 1/2/3/4/5.
o
1: 0-133 ft (0-40 m)
o
2: 133-266 ft (40-81 m)
o
3: 266-399 ft (81-122 m)
o
4: 399-533 ft (122-162 m)
o
5: 533-655 ft (162-200 m)
Example of pricable feedback:
*P pricable a 1
*P pricable b 1
*P pricable c 1
*P pricable d 1
prichan
This command is used to configure the channel hunting strategy for the PRI
interfaces.
prichan