beautypg.com

TANDBERG GW Dataport Command Interface D13202 User Manual

Page 16

background image

TANDBERG GW

Dataport Command Interface User Guide

D13202 Rev 01

16

*P services http on
*P services https on
*P services snmp on
*P services ftp on

sendnum

Enables/disables broadcast of the local unit’s number during H.320 call setup.
NOTE! The transfer of the local number to a remote system or the prevention
thereof is dependent on the feature set supported by the network or networks
between the GW and the endpoint.

sendnum
---

Example of sendnum feedback:
*P sendnum on

snmp

Configures the snmp mib.
Note! For more information about SNMP please read the TANDBERG SNMP
application note.

snmp cn
or
snmp sc
or
snmp sl
or
snmp hi [host ip address] [host ip address]
---

parameters:

community name: Textstring of maximum 16 characters.

system contact name: Textstring of maximum 50 characters

system location name: Textstring of maximum 50 characters

host ip address: ip address


sub-commands:

cn: Used to set the community name parameter.

sc: Used to set the system contact name parameter.

sl: Used to set the system location name parameter.

hi: Used to set the host ip address parameters.


Example of snmp feedback:
*P snmp hi 10.0.2.255 "" ""
*P snmp sl ""
*P snmp sc TANDBERG
*P snmp cn public

sport

This command is used to configure the serial port by setting baudrate, parity,
databits and stopbits.

sport [baudrate] [parity] [databits] [stopbits]
---

parameters:

baudrate: 1200/2400/4800/9600/19200/38400/57600/115200

parity: n/o/e

databits: 7/8

stopbits: 1/2