TANDBERG GW Dataport Command Interface D13202 - Manual (Page 28)

TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 28
4.2.4. Debug Commands
Command: Desription:
eventlog
The eventlog records all serious errors registered by the system. The log
can be used to identify the cause for errors. The complete eventlog can be downloaded
from the embedded FTP server.
eventlog [n/all]
Parameters
• n: Lists the specified number of lines from the end of the eventlog.
• all: List all entries in the eventlog
The eventlog will be deleted when the system is powered off.
dumph221 Dumps the H.221 log of the last call.
dumph221 [0..15/reset]
---
Parameters:
• 0..15: id referring to a video site.
• reset: Resets the GW’s H.221 buffer. The buffer will now be filled up with
new H221 data.
isdntrace Causes D-channel information (layer 2 and 3) for the specified ISDN lines to be
output to the interface that issued the command.
isdntrace [PRI interface]
---
Parameters:
• PRI interface: 1/2/3/4. Identifiers referring to the different PRI interfaces.
syslog Enables a real-time log of Bonding, H.221 and H.323 activity.
Note! When used for H.323 activity the command must be issued through Telnet.
syslog
ping Standard ping command. Used to check if a unit on the network is
reachable.
ping
Example of ping feedback:
ping: 192.168.1.10 is alive (10 ms)
traceroute Standard traceroute command. Used to find out routing information to
specified IP address.
traceroute
Example of traceroute:
traceroute to 12.35.161.100, 30 hops max
1 10.0.0.1 (10 ms)
2 193.212.161.65 (20 ms)
3 146.172.164.129 (40 ms)
4 194.248.135.61 (40 ms)
5 146.172.206.21 (40 ms)