TANDBERG GW Dataport Command Interface D13202 - Manual (Page 14)

TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 14
prichan low <1..23/31>
or
prichan high <1..23/31>
or
prichan search
---
parameters:
• PRI interface: a/b/c/d. Letters identifying the different PRI interfaces.
o a: PRI interface 1
o b: PRI interface 2
o c: PRI interface 3
o d: PRI interface 4
sub-commands:
• max: Sets a limit on the number of channels that will be available for
incoming and outgoing calls.
Values: 1-23 for T1 PRI, 1-30 for E1 PRI.
• low: Used together with high to define the line hunting strategy. The GW
will search for available channels between low and high. This allows other
devices to reserve channels outside this range
Values: 1-23 for T1 PRI, 1-31 for E1 PRI.
• high: ref. low
• search: Specifies if the search for available channels are to start from the
lower or higher limit.
Example of prichan feedback:
*P prichan a max 23
*P prichan a low 1
*P prichan a high 23
*P prichan a search high
pricrc4 Turns the the CRC check for PRI-E1 on/off. CRC is default on and should stay on
in most cases.
pricrc4 [PRI interface]
---
parameters:
• PRI interface: a/b/c/d. Letters identifying the different PRI interfaces. If
this parameter is omitted the given value is set for all interfaces.
o a: PRI interface 1
o b: PRI interface 2
o c: PRI interface 3
o d: PRI interface 4
Example of pricrc4 feedback:
*P pricrc4 a on
*P pricrc4 b on
*P pricrc4 c on
*P pricrc4 d on
prinet Selects ISDN PRI protocol.
prinet
---
parameters:
• protocol: ni/att/euro.
o ni - National ISDN (North America)
o att – AT&T ISDN (North America)