TANDBERG GW Dataport Command Interface D13202 - Manual (Page 31)

TANDBERG GW Dataport Command Interface User Guide
D13202 Rev 01 31
4.3. Parameter Storage
Parameters are set by issuing Parameter Setting Commands, ref. chapter 4.1.2.
All parameters and their corresponding storage type are listed in the table below. The following
definitions are used:
level 0: No storage (RAM). Does not survive boot or any of the “defvalues” combinations.
level 1: Normal storage (EEPROM). Survives boot, but none of the “defvalues” combinations.
level 2: Normal storage (EEPROM). Survives boot and “defvalues set”. Does not survive
“defvalues
set all”.
level 4: Survives everything, except software upgrade and “defvalues set factory”.
Command Storage
directory level 1
gwdid level 2
gwextdialin level 2
gwh323service level 2
gwhotline level 2
gwloadlimit level 2
gwsettings level 2
h323alias level 2
h323gatekeeper level 2
ipaddress level 2
ipassignment level 2
ipmtu level 1
ippassword level 2
ipqos level 2
ipspeed level 2
isdnprot level 2*
netprofile level 2
optionkey level 2
pardial level 1
pricable level 2
prichan level 2
pricrc4 level 2
prinet level 2
protect level 4
sendnum level 1
services level 1
snmp level 2
sport level 2
systemname level 2
*Except sub command sendcomplete: level 1