beautypg.com

TANDBERG GW Dataport Command Interface D13202 User Manual

Page 12

background image

TANDBERG GW

Dataport Command Interface User Guide

D13202 Rev 01

12

Example of ipqos feedback:
*P ipqos prectlph audio auto
*P ipqos diffstlph audio 0
*P ipqos precvtlph audio auto
*P ipqos precvtlph signalling auto
*P ipqos precvtlph video auto
*P ipqos precvtlph data auto
*P ipqos diffsvtlph audio 0
*P ipqos diffsvtlph signalling 0
*P ipqos diffsvtlph video 0
*P ipqos diffsvtlph data 0
*P ipqos mode precedence
*P ipqos tos off
*P ipqos rsvp off

isdnprot

Defines various ISDN protocol settings.

isdnprot nsftel
or
isdnprot nsfvid
or
isdnprot sendcomplete
or
isdnprot restart
or
isdnprot alert
or
isdnprot hlc
---

sub-commands:

nsftel / nsfvid: Selects Network Service Facility for videophony or

telephony on PRI-T1.The NSF can be configured as “” (no value) or any
number between 0-31 to describe the service facility on your PRI-T1 line.
To enter the NSF value you must know the profile used for your line.

sendcomplete: The Q.931 message "Sending complete" can be turned off.

This is only applicable for some Australian switches, which stop outgoing
calls when the message “send complete” is sent to the switch.

restart: When restart is set to on the PRI interfaces will be reinitialized

after boot.

alert: If set to on, the system will respond with an alert message to all

incoming setup messages. If set to off, the system will respond with an
alert message only to the incoming setup message related to the initial
channel.

hlc: Turns sending of HLC information element in setup message on or

off (video calls only).


Example of isdnprot feedback:
*P isdnprot nsftel ""
*P isdnprot nsfvid ""
*P isdnprot sendcomplete off
*P isdnprot restart on
*P isdnprot alert on
*P isdnprot hlct on

netprofile

Network profiles are used to predefine a set of call prefixes to be used by directory
entries.

netprofile [profile name] [network]