beautypg.com

TANDBERG GW Dataport Command Interface D13202 User Manual

Page 19

background image

TANDBERG GW

Dataport Command Interface User Guide

D13202 Rev 01

19

disc
---

parameters:

gwid: 1..16. Identifier referring to a GW call.

gwdid

Sets ISDN DID (Direct Inwards Dialling) parameters. When DID is enabled the GW
will strip of the last digits in the ISDN incoming number and use this extracted
number to dial the h323 terminal. The number of digits to strip of the incoming
number and use as h323 number can be specified.

gwdid mode
or
gwdid numbofdigits
or
gwdid maxbw
or
gwdid h323callprefix
---

parameters:

bw: 64/128/192/256/320/384/512/768/1152/1472/1920


sub-commands:

mode: Enables or disables DID.

numbofdigits: Sets the number of digits to extract from the ISDN

incoming number and use as h323 number.

maxbw: Sets the maximum bandwidth to be used when setting up a GW

call using DID.

h323callprefix: Defines an h323 dial prefix to add to the h323 number

extracted from the incoming ISDN number.

gwextdialin

Defines the ISDN extension dial in mode and corresponding ISDN number. When
the extension dial in number is being called the GW will request an extension
number to connect to the h323 terminal.

gwextdialin [id] mode
or
gwextdialin [id] isdnnumber
or
gwextdialin [id] maxbw
or
gwextdialin [id] description

parameters:

id: 1

bw: 64/128/192/256/320/384/512/768/1152/1472/1920


sub-commands:

mode: Sets the extension dial in mode to off, ivr or ivr/tcs-4.

isdnnumber: Defines the ISDN number the GW will use as ISDN

extension dial in number.

maxbw: Sets the maximum bandwidth to be used when setting up a GW

call using extension dial in.

description: To set an informative text.

gwh323service Defines h323 services. H323 service prefixes are being registered at the gatekeeper.

When dialing from an h323 terminal, one of the GW’s service prefixes must be
dialed followed by the ISDN number to connect to.