TANDBERG GW Dataport Command Interface D13202 User Manual
Page 20
TANDBERG GW
Dataport Command Interface User Guide
D13202 Rev 01
20
gwh323service
gwh323service
gwh323service
gwh323service
gwh323service
•
id: 1..20. Identificator referring to a specific h323service.
•
bw: 64/128/192/256/320/384/512/768/1152/1472/1920
sub-commands:
•
servprefix: Sets the service prefix for this h323 service.
•
maxbw: Sets the maximum bandwidth to be used when setting up a GW
call using this h323 service.
•
isdncallprefix: Defines an isdn call prefix to be added to the ISDN number
to dial.
•
restrict: Sets restrict to on or off.
•
description: To set an informative text for this h323 service.
gwhotline
Hotline numbers are used to map an incoming ISDN number to an h323 number.
gwhotline
gwhotline
gwhotline
gwhotline
•
id: 1. Identificator referring to a specific hotline entry.
•
bw: 64/128/192/256/320/384/512/768/1152/1472/1920
sub-commands:
•
isdnnumber: Defines the hotline ISDN number.
•
h323alias: Defines the corresponding h323 number for this hotline entry.
•
maxbw: Sets the maximum bandwidth to be used when setting up a GW
call using this hotline.
•
description: To set an informative text for this hotline entry.
NOTE! Only one hotline entry is supported in this version of the TANDBERG GW.
gwloadlimit
The GW will signal busy to the gatekeeper when the current load on the GW reaches
this limit.
The current system load can be monitored by the status command systemload.
gwloadlimit <0..100>
gwsettings
To avoid interoperability problems, the GW can be configured to not support some
features.
gwsettings natvid
gwsettings customformats