Section 4.5 – Texas Instruments TMS320DM36X User Manual
Page 73
www.ti.com
MDIO Registers
4.5
MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
The MDIO link status change interrupt (unmasked) register (LINKINTRAW) is shown in
and
described in
.
Figure 30. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
31
16
Reserved
R-0
15
2
1
0
Reserved
LINKINTRAW
R-0
R/W1C-0
LEGEND: R = Read only; R/W = Read/Write; W1C = Write 1 to clear, write of 0 has no effect; -n = value after reset
Table 27. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
Field Descriptions
Bit
Field
Value
Description
31-2
Reserved
0
Reserved
1-0
LINKINTRAW
0-3h
MDIO Link change event, raw value. When asserted, a bit indicates that there was an MDIO link
change event (that is, change in the LINK register) corresponding to the PHY address in the
USERPHYSEL register. LINKINTRAW[0] and LINKINTRAW[1] correspond to USERPHYSEL0 and
USERPHYSEL1, respectively. Writing a 1 will clear the event and writing a 0 has no effect.
0
No MDIO link change event.
1
An MDIO link change event (change in the LINK register) corresponding to the PHY address in
MDIO user PHY select register n (USERPHYSELn).
73
SPRUFI5B – March 2009 – Revised December 2010
Ethernet Media Access Controller (EMAC)/Management Data Input/Output
(MDIO)
© 2009–2010, Texas Instruments Incorporated