beautypg.com

Troubleshooting —continued – Onkyo 29344937 User Manual

Page 96

background image

96

Troubleshooting

—Continued

Can’t record
• On your recorder, make sure the correct input is

selected.

• To prevent signal loops and damage to the AV

receiver, input signals are not fed through to outputs
with the same name (e.g., TV/TAPE IN to TV/TAPE
OUT or VCR/DVR IN to VCR/DVR OUT).

• When the Pure Audio listening mode is selected,

video recording is not possible because no video
signals are output. Select another listening mode.

The sound changes when I connect my
headphones
• When a pair of headphones is connected, the listening

mode is set to Stereo, unless it’s already set to Stereo,
Mono, Direct, or Pure Audio, in which case it stays the
same. (Pure Audio listening mode is not available for
North American models.)

How do I change the language of a multiplex
source
• On the “Audio Adjust” menu, change the “Input

(Mux)” setting to “Main” or “Sub” (page 71).

The

functions don’t work

• To use

, you must make an

connection and an

analog audio connection (RCA) between the
component and AV receiver, even if they are
connected digitally (page 39).

• While Zone 2 is selected, the

functions don’t

work.

The AV receiver’s display doesn’t work
• The display is turned off when the Pure Audio

listening mode is selected. Select another listening
mode.

The following settings can be made for the
composite video inputs
You must use the buttons on the unit to make these
settings.
1. While holding down the input selector button for the

input source that you want to set, press the [SETUP]
button.

2. Use the Left and Right [

]/[

] buttons to change

the setting.

3. Press the input selector button for the input source

that you want to set when you’ve finished.

• Video Attenuation

This setting can be made for the DVD/BD,
VCR/DVR, CBL/SAT, or AUX input.
If you have a games console connected to the
composite video input, and the picture isn’t very
clear, you can attenuate the gain.
Video ATT:0: (default).
Video ATT:2: Gain is reduced by 2 dB.

Recording

Others

The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least 5 seconds, and then plug it back
in again.

Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
this unit’s malfunction. Before you record important
data, make sure that the material will be recorded
correctly.

Before disconnecting the power cord from the wall
outlet, set the AV receiver to Standby.

This manual is related to the following products: