Onkyo 29344937 - Manual (Page 54)

54
Listening to the Radio
—Continued
With the built-in tuner, you can enjoy AM and FM radio
stations and store your favorite stations as presets for
easy selection.
Listening to the Radio
Tuning into AM/FM Radio Stations
■ Auto Tuning Mode
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
■ Manual Tuning Mode
This model changes FM/AM frequency in 200 k/10 k (or
50 k/9 k) Hz steps.
In Manual Tuning mode, FM stations will be in mono.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
You can also use the remote controller’s Up and Down
[ ]/[ ] buttons to tune the radio.
Using the Tuner
Use the [TUNER] input selector
button to select “AM” or “FM”.
In this example, FM has been selected.
(Actual display depends on country.)
1 Press the [TUNING MODE]
button so that the AUTO indicator
appears on the display.
2 Press the TUNING Up or Down
[ ]/[ ] button.
Searching stops when a station is
found.
TUNING TUNER
TUNING MODE
Band Frequency
FM STEREO
AUTO
TUNED
1 Press the [TUNING MODE]
button so that the AUTO indicator
disappears from the display.
2 Press and hold the TUNING Up or
Down [ ]/[ ] button.
The frequency stops changing when
you release the button.
Press the button repeatedly to change
the frequency one step at a time.