Onkyo 29344937 - Manual (Page 14)

14
Speaker Package
For detailed information, see the pages in parentheses.
■ Front
■ Rear
STANDBY/ON indicator
With the Auto Standby function, the SKW-770
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-770 automatically
enters Standby mode.
POWER switch (Asian models)
Press this switch to the ON position to turn on the
power. Press it to the OFF position to turn off the
power.
OUTPUT LEVEL control (49)
This control is used to adjust the volume of the
subwoofer.
LINE INPUT (20)
This RCA input should be connected to the
subwoofer pre out on the AV receiver with supplied
RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
the AV receiver (page 70).
Subwoofer (SKW-770)
SKW-770
ON
OFF
POWER
To AC outlet
Asian models
Red: Subwoofer in standby mode
Blue: Subwoofer on