beautypg.com

Remote controller, Installing the batteries, Aiming the remote controller – Onkyo 29344937 User Manual

Page 16: Ol sensor (16)

background image

16

Remote Controller

Notes:
• If the remote controller doesn’t work reliably, try

replacing the batteries.

• Don’t mix new and old batteries or different types of

batteries.

• If you intend not to use the remote controller for a long

time, remove the batteries to prevent damage from
leakage or corrosion.

• Expired batteries should be removed as soon as

possible to prevent damage from leakage or corrosion.

When using the remote controller, point it toward the AV
receiver’s remote control sensor, as shown below.

Notes:
• The remote controller may not work reliably if the AV

receiver is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.

• If another remote controller of the same type is used in

the same room, or the AV receiver is installed close to
equipment that uses infrared rays, the remote
controller may not work reliably.

• Don’t put anything on top of the remote controller,

such as a book or magazine, because a button may be
pressed continuously, thereby draining the batteries.

• The remote controller may not work reliably if the AV

receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.

• The remote controller will not work if there’s an

obstacle between it and the AV receiver’s remote
control sensor.

• When the remote control codes have been registered

and you want to operate another component (page 84),
or when you want to operate an Onkyo component
without

connection, point the remote controller at

the other component to use it.

• When you want to operate an Onkyo component with

connection or an

-compatible compo-

nent connected via HDMI (pages 86, 87), point the
remote controller at the AV receiver’s remote control
sensor.

Installing the Batteries

1

To open the battery compartment, press
the small lever and remove the cover.

2

Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.

3

Replace the cover and push it shut.

Aiming the Remote Controller

30°

30°

Approx. 16 ft.
(5 m)

Remote control sensor

AV receiver

This manual is related to the following products: