Onkyo 29344937 - Manual (Page 75)

75
Advanced Setup
—Continued
You can assign a default listening mode to each input
source that will be selected automatically when you
select each input source. For example, you can set the
default listening mode to be used with Dolby Digital
input signals. You can select other listening modes
during playback, but the mode specified here will be
resumed once the AV receiver has been set to Standby.
Notes:
• If you connect an input component (such as UP-A1
series Dock that seated iPod or iPhone) to the UNI-
VERSAL PORT jack, you can assign only “Anlg
(Analog)” listening mode to PORT input selector.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Assigning Listening Modes to Input
Sources
1 Press the [RECEIVER] button followed by
the [SETUP] button.
2 Use the Up and Down [ ]/[ ] buttons to
select “5. ListeningMode”, and then press
[ENTER].
3 Use the Up and Down [ ]/[ ] buttons to
select the input source that you want to
set, and then press [ENTER].
For TUNER input selector only “Anlg (Analog)”
will be available.
4 Use the Up and Down [ ]/[ ] buttons to
select the signal format that you want to
set, and then use the Left and Right
[
]/[ ] buttons to select a listening
mode.
Only listening modes that can be used with each
input signal format can be selected (see pages 62-
65).
The Last Valid option means that the listening
mode selected last will be used.
A/PCM: With this setting, you can specify the
listening mode to be used when an analog (CD,
TV, LD, VHS, MD, turntable, radio, cassette,
cable, satellite, etc.) or PCM digital (CD, DVD,
etc.) audio signal is played.
Dolby: With this setting, you can specify the
listening mode to be used when a Dolby Digital or
Dolby Digital Plus format digital audio signal is
played (DVD, etc.).
DTS: With this setting, you can specify the
listening mode to be used when a DTS or DTS-
HD High Resolution format digital audio signal is
played (DVD, LD, CD, etc.).
DF2ch: Specifies the default listening mode for
2-channel (2/0) stereo sources in a digital format,
such as Dolby Digital or DTS.
Mono: With this setting, you can specify the
listening mode to be used when a mono digital
audio signal is played (DVD, etc.).
MCH P: Specifies the default listening mode for
multichannel PCM sources input via a HDMI IN,
such as DVD-Audio.
True: Specifies the default listening mode for
Dolby TrueHD sources, such as Blu-ray or HD
DVD (input via HDMI).
MSTR: Specifies the default listening mode for
DTS-HD Master Audio sources, such as Blu-ray
or HD DVD (input via HDMI).
DSD: Specifies the default listening mode for
DSD multichannel sources, such as SACD.
5 When you’ve finished, press the [SETUP]
button.
Setup closes.