Onkyo 29344937 - Manual (Page 41)

41
First Time Setup
This section explains the settings that you need to make before using the AV receiver for the very first time.
If you connect a video component to an HDMI IN, you
must assign that input to an input selector. For example,
if you connect your DVD player to HDMI IN1, you must
assign HDMI IN1 to the DVD/BD input selector.
Notes:
• Each HDMI IN cannot be assigned to more than one
input selector.
• When an HDMI IN is assigned to an input selector as
explained here, the digital audio input for that input
selector is automatically set to the same HDMI IN.
See “Digital Input Setup” on page 43.
• If you connect an input component (such as UP-A1
series Dock that seated iPod or iPhone) to the
UNIVERSAL PORT jack, you cannot assign any
input to PORT selector.
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
• Do not assign the component connected with the
HDMI input to the TV/TAPE selector when you set
“TV Ctrl” setting to “On” (see page 79). Otherwise,
appropriate CEC (Consumer Electronics Control)
operation is not guaranteed.
HDMI Input Setup
Input selector Default assignment
DVD/BD HDMI1
VCR/DVR HDMI2
CBL/SAT HDMI3
AUX - - - - -
TV/TAPE - - - - -
CD - - - - -
PORT - - - - -
1 Press the [RECEIVER] button,
followed by the [SETUP] button.
2 Use the Up and Down [ ]/[ ]
buttons to select “1. Input
Assign”, and then press
[ENTER].
SETUP
RECEIVER
ENTER
3 Use the Up and Down [ ]/[ ]
buttons to select “1-1. HDMI”,
and then press [ENTER].
4 Use the Up and Down [ ]/[ ]
buttons to select an input
selector, and use the Left and
Right [
]/[ ] buttons to select:
HDMI1: Select if the video
component is connected to
HDMI IN 1.
HDMI2: Select if the video
component is connected to
HDMI IN 2.
HDMI3: Select if the video
component is connected to
HDMI IN 3.
HDMI4: Select if the video
component is connected to
HDMI IN 4.
- - - - -: Select if you’re not using the
HDMI OUT.
5 Press the [SETUP] button.
Setup closes.