Adjusting the bass & treble, Displaying source information, Ttons (50, 83) – Onkyo 29344937 User Manual
Page 50: Basic operations —continued
50
This section explains functions that can be used with any
input source.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio listening mode is
selected.
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
You can display various information about the current
input source as follows.
Note:
This procedure can also be performed on the AV receiver
by using its [DISPLAY] button.
The following information can typically be displayed:
*1 When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is analog, or AM or FM radio is selected, no
format information is displayed. If the input signal is PCM, the
sampling frequency is displayed. If the input signal is digital but
not PCM, the signal format is displayed. Information is
displayed for about 3 seconds, then the previous display
reappears.
Adjusting the Bass & Treble
AV receiver
Press the [TONE] button
repeatedly to select either
“Bass” or “Treble”.
Use the TONE [–]/[+] buttons to
adjust.
Tip:
This procedure can also be performed
on the remote controller by using
[AUDIO] button (see page 73).
MUTING
DISPLAY
SLEEP
DIMMER
PHONES
TONE [–]/[+]
DISPLAY
DIMMER
MUSIC OPTIMIZER
Press
[RECEIVER]
first
Displaying Source Information
Press the [RECEIVER] button,
and then press the [DISPLAY]
button repeatedly to cycle
through the available
information.
Input source &
volume
*1
Signal format
*2
or sampling
frequency
Input source &
listening mode