Controlling other components, Preprogrammed remote control codes, Entering remote control codes – Onkyo 29344937 User Manual
Page 84: See “controlling other components
84
Controlling Other Components
You can control your DVD player, CD player, and other
components with the AV receiver’s remote controller.
To control another component, you must first enter that
component’s remote control code to a REMOTE MODE
button.
This section explains how to enter remote control codes
and how to control your other components.
The following REMOTE MODE buttons are
preprogrammed with remote control codes for
controlling the components listed. You do not need to
enter a remote control code to control these components.
For details on controlling these components, see the
pages indicated.
Onkyo DVD/BD player (page 87)
Onkyo CD player (page 90)
Onkyo cassette recorder with
You’ll need to enter a code for each component that you
want to control.
Note:
The remote control codes provided are correct at the time
of printing but subject to change.
Preprogrammed Remote Control
Codes
Entering Remote Control Codes
REMOTE
MODE
RECEIVER
DISPLAY
Number
buttons
Remote
indicator
1
Look up the component’s remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
2
While holding down the REMOTE
MODE button to which you want
to enter a code, press and hold
down the [DISPLAY] button until
the Remote indicator lights up
(about 3 seconds).
Notes:
• Remote control codes cannot be
entered for the [RECEIVER] and
[ZONE 2] buttons.
• Only TV remote control codes can be
entered for the [TV] button.
• Apart from the [RECEIVER], [TV],
and [ZONE 2] buttons, remote
control codes from any category can
be entered for the REMOTE MODE
buttons. However, these buttons also
work as input selector buttons
(page 49), so choose a REMOTE
MODE button that corresponds with
the input to which you connect your
component. For example, if you
connect your CD player to the CD
input, choose the [CD] button when
entering its remote control code.
3
Within 30 seconds, use the
number buttons to enter the 5-
digit remote control code.
The Remote indicator flashes twice.
If the remote control code is not entered
successfully, the Remote indicator will
flash once slowly.
(3 seconds)