Onkyo 29344937 - Manual (Page 74)

74
Advanced Setup
—Continued
CinemaFILTER
With the CinemaFILTER, you can soften overly bright movie soundtracks, which are typically mixed for
reproduction in a movie theater.
CinemaFILTER can be used with the following listening modes: Dolby Digital, Dolby Digital EX, Dolby Digital
Plus, TrueHD, Dolby Pro Logic IIx Movie, Dolby Pro Logic II Movie, Multichannel, DTS, DTS-ES, DTS Neo:6
Cinema, DTS 96/24, Neo:6, DTS-HD High Resolution, DTS-HD Master and DTS Express.
Cinema Fltr Off: CinemaFILTER off (default).
On: CinemaFILTER on.
Note:
The CinemaFILTER may not work when used with certain input sources.
Audyssey Dynamic Volume™
Dyn Vol See “Dyn Vol” of “Audio Adjust” on page 72.
Music Optimizer
The Music Optimizer function enhances the sound quality of compressed music files. Use it with music files that
use “lossy” compression, such as MP3.
M.Optimizer Off: Music Optimizer off (default).
On: Music Optimizer on.
Note:
The Music Optimizer function only works with PCM digital audio input signals with a sampling rate below 48 kHz and
analog audio input signals. The Music Optimizer is disabled when the Direct or Pure Audio listening mode is selected.
Speaker Layout
You can select the priority of the use of SurrBack speakers or FrontHigh speakers.
SpLayout
SurrBk: The sound from surround back speakers is output by priority.
FrontH: The sound from front high speakers is output by priority.
Notes:
• If the “Sp Type” setting is set to “Bi-Amp” (page 44) or Powered Zone 2 is being used, this setting cannot be
selected.
• When the listening mode that doesn’t correspond to the switch of the speakers is used, the setting cannot be selected.
• This setting can also be selected on the remote controller by using [GUIDE/TOP MENU] button.
Speaker Levels
You can adjust the volume of each speaker while listening to an input source.
These temporary adjustments are cancelled when the AV receiver is set to Standby.
Subwfr (Subwoofer)
–15 dB to +12 dB (default: 0 dB)
Center –12 dB to +12 dB (default: 0 dB)
Notes:
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the “2-2. Sp Config (Speaker Configuration)” cannot be adjusted
(see page 68).
A/V Sync
When using progressive scanning on your DVD player, you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the audio signals.
A/V Sync 0 ms to 100 ms in 10 ms steps
Notes:
• A/V Sync is disabled when the Pure Audio listening mode is selected, or when the Direct listening mode is
used with an analog input source.
• The setting is stored individually for each input selector.