Roland KR105 - Manual (Page 15)

15
Before You
Start Playing
Before You Start Playing
Connect the Pedal Cable
Insert the pedal cable into the Pedal connector on the
rear panel of the KR105.
fig.00-01
Connect the Power Cord
Insert the included power cord into the AC inlet on the
bottom panel of the KR105, and then plug it into an
electrical outlet.
NOTE
Be sure to use the supplied power cord.
fig.00-02
Setting Up the Music Rest
Set up the music rest as shown in the figure below.
Fold the three supporting feet at the back of the rest and
check whether the stand is held in place.
Before moving the KR105, be sure to lower the music
stand as a safety precaution.
■ Using the Music Holders
You can use the holders to hold pages in place. When not
using the holders, leave them folded down.
fig.mu_stand4
KR105.book Page 15 Tuesday, June 7, 2005 5:25 PM