Raymarine GPS navigation - Manual (Page 55)

Example: Press for
Check the direction displayed to the left of the Latitude. Use to
change to or vice versa. save the Latitude.
Estimated Longitude
The prompt now moves to request your Longitude entry . Type in the correct
longitude value. Add a for Longitudes below 100 degrees.
Example: Press for 59.85’
Check the direction displayed to the left of the Longitude. Press
key to change to or vice versa. Press to complete the
longitude entry.
pressed to complete your Longitude entry, you will be
prompted to enter the antenna height.
Antenna Height Entry
The display changes and prompts to "ENTER ANT HEIGHT" above sea level
in
METERS
(3.28 feet = 1 meter) or in Enter the numeric value of
you antennas height above the water. Then When
appears on the screen, press the only if you want to change
the units from meters to feet or vice versa. The units selection appears
after the antenna height digits on the display. Then
is pressed to accept your antenna
height, the unit will advance the message prompt
to request the date entry.
Date Entry
For this entry you need to type in sequence the
two digits of the Month, followed by two digits
for followed by two digits for the current
Year. When the readout looks OK, press
18.25.14
When (ENTER7 is pressed to accept the Date
entry, the display advances to enter the Local
PRESS ENTER TO RETURN
For May press
26
time.
NOTE: R E T U R N S T O
S I G N A L S T A T U S
, OPERATION 3-42