Raymarine GPS navigation - Manual (Page 36)

any blank space in the typewriter box and then press the required to
add the character.
If you make a mistake, just position the
ABC GHI STU
blinking cursor over the incorrect character
with the
(REV) key and re-type the
D E F J K L 8 9 0
.
character in its place.
When the NAME is complete, press key. If you want to bypass
this page without naming the until later, just press key.
In the meantime, this “unnamed” will be designated by a “diamond”
shapped symbol on the plot screen.
3.6.4 Storing Waypoints
Once is pressed on the NAME s c r e e n , t h e d i s p l a y
changes to the STORE TYPE screen so you can select the type of
coordinate data to enter.
STORE TYPE
If you wish to enter the coordinates in
Latitude/ Longitude, press
STORE
key.
To enter the coordinates in Loran-C
Time Differences, press
To enter a position as a bearing and range from your present
position, press
3.6.4.1 Storing by
Enter the Latitude coordinates by typing the numeric value in
degrees, minutes and hundreths of minutes. when the value is
correct if the direction is OK. Use the to select
“S”, if necessary.
Example: Press
.
Latitude = N 10.15’
If you are editing or correcting an existing
point and the Latitude is already correct, just
press to advance directly to the .
Longitude entry.
- - -
OPERATION 3-22