Raymarine GPS navigation - Manual (Page 29)

Press
the [TRACK
until the desired memory interval is
highlighted by the block. Now track recording will be ON.
The
NAV
unit has Auto Start/Stop plotting built in. So, if you should stop
along the way to fish, and forget to turn the track recording interval off, the
tracker should automatically stop plotting until you’re moving again.
All track points recorded will be “saved” in track memory until erased, or
unless overwritten by new track data. When track points are overwritten, the
newest track point
will replace old track point track point
replaces etc.
When you are finished recording the track, re-enter the
TRACK
menu and
select “OFF”
with the
T
RA
CK INTERVAL to turn the memory
recording interval to “OFF”.
Press twice when you are ready to return to the previous
display mode to back out of the menus.
Erasing a Track Line
Since only one track line can be stored to memory at any time in the NAV
unit, it’s a good idea to erase the old track from memory before starting to
record a new track plot.
Just select TRACK menu from the PLOT menu by pressing
Press
ERASE TRACK
and then press
key to actually confirm that you wanted to erase the track memory. When
pressed, all track data will be erased.
Press when ready to return to the previous display mode
twice to back out of the menus.
Plot Display Menu
PLOT MENU
If the Plot screen becomes cluttered with the event and
TRACKLINE
symbols, the memorized track line, or the
r l
Position readouts. The PLOT DISPLAY
menu provides
MARKS
options to turn marks, track or data ON or OFF.
Track ON/OFF
Waypoints Marks ON/ OFF
Position readout ON/ OFF
PRESS CLEAR TO EXIT I
OPERATION 3-15