Raymarine GPS navigation - Manual (Page 47)

When-is pressed the route sequence will be ON. The route
number will be displayed in the left corner of the bar
on the POS, NAV, or screens and the first point of the route plan
becomes your initial destination, unless you happen to already be at the first
point of the route.
While you are following the route plan you may press
anytime to bypass the next point in the route plan.
Turning the Route OFF
The route plan can be conveniently turned OFF anytime by pressing the
the FOLLOW ROUTE screen press the
One other method of turning the route sequence to OFF is a bit indirect but
if you press to select any that is not part of the route
plan, or press , the route will be turned OFF.
3.9.3 Editing Route Plans
The EDIT ROUTE mode is used to
INSERT
or
DELETE
waypoints in a route
plan or to ERASE a route plan in its’ entirety.
Press the key. Press the EDIT ROUTE
Selection screen appears, select the route number you
EDIT ROWE
wish to edit.
I
SELECT ROUTE
On the EDIT ROUTE screen the route legs can be
examined and the bearing and distance of the high-
lighted leg of the route plan displayed. If changes are
necessary, you can insert or delete waypoints in the
legs in a route by performing the following key opera-
tions:
The EDIT ROUTE display shows the Route # and
the leg containing the first two in the
route. To see other waypoints in the legs of the route,
of interest in the highlighted block to check the bearing
and distance.
OPERATION