Roland Jupiter 80 - Manual (Page 67)

Editing a Synth Tone
67
In
tr
oduc
tion
Pla
ying S
ounds
Editing S
ounds
O
ther C
on
venien
t
Func
tions
Connec
ting O
ther
Equipmen
t
A
ppendix
• If a Synth Tone has been edited, a check mark (yellow) is shown
at the right of the tone name.
Volume and On/Off Settings for Each
Partial
You can turn a Partial on/off by touching the .
By touching you can select the Partial that you
want to edit.
Status
Lit red On
Unlit Off
Status
Lit green Selected
Unlit –
MEMO
• You can select two or more Partials by holding down the [SHIFT]
button and touching .
• When the Synth Tone Edit screen is displayed, you can use the
PART BALANCE area of the panel to turn the three Partials on/off
and adjust their volume.
Turns each Partial
on/off.
Controls the AMP level
of each Partial.
The AMP level of each
Partial is shown by the
level meter.
• By holding down the [SHIFT] button and pressing the PART
[PERC ON/OFF], [LOWER ON/OFF], or [UPPER ON/OFF] buttons,
you can select the Partial that you want to edit.
PART button Selected Partial
PART [PERC ON/OFF] Partial 1
PART [LOWER ON/OFF] Partial 2
PART [UPPER ON/OFF] Partial 3
• To edit two or more Partials, simultaneously hold down the PART
buttons of the Partials that you want to edit.