Roland Jupiter 80 - Manual (Page 50)

50
Changing the Keyboard Settings
Changing the Pitch by Octaves
By pressing the OCTAVE [DOWN] button or OCTAVE [UP] button you
can shift the keyboard’s pitch range in steps of an octave.
When using your right hand to play low sounds such as the bass
Part, it will be easier to play if you lower the pitch range by one or
two octaves.
1.
Press the OCTAVE [DOWN] button or OCTAVE [UP] button .
A message will appear when you press the button.
• Pressing the OCTAVE [DOWN] button raises the pitch by one
octave; pressing the OCTAVE [UP] button lowers the pitch by
one octave.
• The pitch can be changed in a range of three octaves down (-3)
to three octaves up (+3).
• If the value is anything other than “0,” the OCTAVE [DOWN]
button or OCTAVE [UP] button will light.
• If you press the OCTAVE [DOWN] button and OCTAVE [UP]
button simultaneously, the value will be reset to “0.”
• The octave shift setting is saved in the Registration.
• If you want to change the octave setting of each Part, edit the
Octave setting in the “Registration Part screen” (p. 31), and save
the Registration.
• If you want to change the octave setting of each layer in the
Live Set, edit the Octave setting in of the Live Set Layer
screen (p. 32), and save the Live Set.
• The octave shift function does not affect the Manual Percussion.
• The split point and solo split point will not change.
Transposing
Transpose is a function that shifts the keyboard’s pitch range in
steps of a semitone.
By using this setting, a transposing instrument such as trumpet or
clarinet can be played at the pitches shown in the printed score.
1.
Hold down the [TRANSPOSE] button and press the
OCTAVE [DOWN] button or OCTAVE [UP] button .
A message will appear when you press the button. The Registration
screen will show the amount of transposition.
Amount of transposition
• Specify the amount of transposition in semitone steps (G–F#:
-5 – +6 semitones).
• If the value is anything other than “0,” the [TRANSPOSE] button
will light.
• You can use the [TRANSPOSE] button to turn Transpose on/off
(when the Transpose setting is other than 0).
• If you hold down the [TRANSPOSE] button and press
the OCTAVE [DOWN] button and OCTAVE [UP] button
simultaneously, the value will be reset to “0.”
• The transpose setting is saved in the Registration.
• The Transpose function does not apply to Drums/SFX or Manual
Percussion.
• The split point and solo split point will not change.