Regency P40 - Manual (Page 45)

Regency ® P40-1 Direct Vent Gas Fireplace 45
MAINTENANCE
MAINTENANCE
CAUTION: Wear gloves when
removing damaged or broken
glass.
WARNING: Do not operate the
appliance with the glass panels
removed, cracked or broken.
Replacement of the glass panels
should be done by a licensed or
qualifi ed service person.
DOOR GLASS
Your Regency ® fi replace is supplied with high
temperature 5mm-Ceramic glass. If your glass
requires cleaning, we recommend using an
approved glass cleaner available at all authorized
dealers. Do not use abrasive materials.
CAUTION & WARNINGS:
* Do not clean when the glass is hot.
* The use of substitute glass will void all product
warranties.
* Care must be taken to avoid breakage of the
glass.
* Do not strike or abuse the glass.
* Do not operate this fi replace without the
glass front or with a cracked or broken glass
front.
* Wear gloves when removing damaged or
broken glass.
* Replacement of the glass panel(s) should be
done by a licensed or qualifi ed service per
son.
GLASS REPLACEMENT
In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency
® dealer only.
Replacement glass is shipped already installed
into the door frame. Reinstall as per Glass Door
Installation in "Standard Flush Door" section.
1) Unplug the power source.
2) Remove the power module by lifting it up
off of the velcro and pull out.
Power Module
3) Undo the wire holder by releasing tab.
4) Remove the Control module by lifting it up
and off to the side.
5) Unplug the J1, J2 and J3 harness at the ECS
module and pull out the Control module.
Control Module
6) Remove the fan ground wires.
7) Disconnect the brown and blue wires
connected to the J1 harness.
8) Release the 2 wire tabs.
9) Remove both fans by lifting up off of the
pins and tilt sideways and then slide to the
left of the fi rebox and pull out carefully.
10) Reverse steps to re-install.
NOTE: To facilitate easier re-installation of the
fans, apply some lubricante to the rubber grom-
mets at the base of the fan bracket.
FAN REPLACEMENT
J1 J2 J3