Regency P40 - Manual (Page 39)

Regency ® P40-1 Direct Vent Gas Fireplace 39
INST
ALLA
TION
INSTALLATION
Upper Air Register
Simply push in the Full Screen Door Frame until it aligns
against the fi nished wall. Secure Top Flange of Full
Screen Door Frame as described in step 4b.
For the Bottom Flange of the Full Screen Door Frame,
push the bottom of the Frame until it aligns with the wall.
Use the inner cutouts to secure the base of the Frame
using the 2x #8 Hex Head Drill Point Screws provided.
7) Secure the Manual Control Panel to the Lower Air
Register with two #8 Self Tapping Phillips screws
(provided) at the right hinge bracket.
Lower Air
Register
Hinge Location
8) Slide the Upper Air Register into the louver brackets
located on the inside top of the fi rebox. Push in
place.
9) Install the Left and Right Side Screen Doors in the
fully open position by placing over top of the hinges
on the Full Screen Door Frame.
NOTE: Failure to install the doors in the fully open
position could result in paint damage to the surface
of the door.
Bottom Flange
Cut Outs
Rear view of Full
Screen Door
Frame Shown
5) Re-install Glass Door. Refer to the manual for
instructions (Page 32).
6) Place the Lower Air Register near hinges. Flip the
two hinges over onto the Lower Air Register and
secure with 2x #8 Self Tapping Phillips Screws per
side.
Right Side
of Lower Air
Register
Hinge
Bracket
Manual Control
Panel
10) Close screen doors.
Hinge
Screen
Door