Regency P40 - Manual (Page 25)

Regency ® P40-1 Direct Vent Gas Fireplace 25
INST
ALLA
TION
INSTALLATION
P40-NG1 SYSTEM DATA
For 0 to 4500 feet altitude
Front Burner Orifi ce:
#44
Back Burner Orifi ce: #35
Max. Input Rating 45,000 Btu/h
Min. Input Rating
13,000 Btu/h
Supply Pressure min.5.0" w.c.
Manifold Pressure
(High) 3.5"+/-
0.3"w.c.
Log Set: Ceramic fi bre,
8 per set + ember bed.
Vent System: Simpson Dura-Vent Direct
Vent System, Regency
® Flex Kit, Selkirk
Direct-Temp
P40-LP1 SYSTEM DATA
Conversion Kit# 502-969
For 0 to 4500 feet altitude
Front Burner Orifi ce:
#55
Back Burner Orifi ce: #53
Max. Input Rating 43,000 Btu/h
Min. Input Rating
12,000 Btu/h
Supply Pressure min.12.0" w.c.
Manifold Pressure
(High)
10"+/- 0.5" w.c.
Log Set: Ceramic fi bre,
8 per set + ember bed.
Vent System: Simpson Dura-Vent Direct
Vent System, Regency
® Flex Kit, Selkirk
Direct-Temp
Periodically check the pilot fl ames. Correct
fl ame pattern has three strong blue fl ames:
1 fl owing around the thermopile, 1 around
the thermocouple and 1 fl owing across the
burner (it does not have to be touching the
burner).
Note: If you have an incorrect fl ame pattern,
contact your Regency ® dealer for
further instructions.
Incorrect fl ame pattern will have small,
probably yellow fl ames, not coming into
proper contact with the rear burner or
thermopile or thermocouple.
PILOT ADJUSTMENT GAS LINE
INSTALLATION
The gas line can be brought through the bottom
right of the appliance. The gas valve is situated
on the bottom of the unit.
The gas line connection may be made of rigid
pipe, copper pipe or an approved fl ex connector.
(If you are using rigid pipe, ensure that the valve
can be removed for servicing.) Since some
municipalities have additional local codes it is
always best to consult with your local authorities
and the CAN/CGA B149 installation code.
For USA installations follow local codes and/or the
current National Fuel Gas Code, ANSI Z223.1.
HIGH ELEVATION
This unit is approved in Canada for altitude 0 to
4500 ft. (CAN1 2.17-M91).
When using copper or fl ex connectors use only
approved fi ttings. Always provide a union so
that gas lines can be easily disconnected for
servicing. Flare nuts for copper lines and fl ex
connectors are usually considered to meet this
requirement.
IMPORTANT: Always check for gas leaks
with a soap and water solution or gas leak
detector. Do not use open fl ame for leak
testing.