Roland CDX-1 - Manual (Page 157)

157
Using the CDX-1 with other MIDI devices
Using the CDX-1 with
other MIDI devices
Using the CDX-1 as an MMC slave
1. Make the following connections.
fig.5-31
The CDX-1 will be the MMC slave, but the MTC master.
2. Press [UTILITY].
The Menu are displayed as icon.
fig.12-06
3. Press CURSOR [ ] to select the MIDI
icon.
4. Press [YES/ENTER].
The MIDI settings screen appears.
fig.12-07
5. Press CURSOR [ ] to move the cursor to
“MMC Mode” line.
6. Turn the TIME/VALUE dial to select “SLAVE.”
For details on the MMC Mode, refer to step 6 of “Using the CDX-1 as the MMC
master,” above.
7. Make settings to allow MTC synchronization.
Perform steps 5 and following of “Using MTC (master)” (p. 154).
8. Make settings on your sequence software.
Make the following settings on your sequencer software. For details on making these
settings, refer to the manual for your sequencer software.
• MTC: receive
• MTC type: same setting as the MTC Type selected on the CDX-1
• MMC: transmit
9. Press [DISPLAY] to return to the Basic screen.
MIDI OUT MIDI OUT MIDI IN MIDI IN
CDX-1
For details on the MMC
functionality that is supported,
refer to “MIDI
Implementation” (p. 212).