Roland HPi-6 - Manual (Page 48)

48
Adding Variety to Your Performances
■ Adding Reverberation to the Sound (Reverb)
By applying the reverb effect you can produce a pleasant reverberation, making it
sound as though you were performing in a concert hall.
fig.d-Effect2-e
1.
Press the [Reverb] button.
The button’s indicator will light, and a reverb effect will be applied to the sound.
To cancel the reverb effect, press the [Reverb] button, getting its indicator to go dark.
■ Adding Richness to the Sound (Chorus)
By applying the chorus effect you can make the sound richer and more spacious.
You can turn the chorus effect on and off for each tone individually.
1.
Press the [Menu/Lesson] button.
The Menu screen appears.
2.
Press the cursor button to select , then press the [ ]
button.
3.
Press the cursor button to select , then press the [ ]
button.
4.
Press the cursor right button to select .
fig.d-Effect2-e
Applying Effects to the Sound
NOTE
It is not possible to memorize
the reverb effect setting for
each tone.
The depth of the reverb effect
can be adjusted. Refer to
“Adjusting the Depth of the
Effects (Effect)” (p. 81).
You can change the amount of
reverb applied by holding
down the [Reverb] button and
pressing the cursor up
or down button.
HPi-6-e.book 48 ページ ２００５年１１月１５日 火曜日 午後３時４９分