Roland HPi-6 - Manual (Page 18)

18
Before You Begin Playing
■ Opening and Closing the Lid
Opening the Lid
1. Use both hands to lift the lid lightly, and slide it away
from yourself.
fig.Lid
Closing the Lid
1. Pull the lid gently toward yourself, and lower it softly
after it has been fully extended.
NOTE
Be careful not to get your fingers pinched when opening or closing
the lid. If small children will be using the HPi-6, adult supervision
should be provided.
NOTE
To prevent accidents, the lid must be closed when transporting the
piano.
■ Turning the Power On/Off
NOTE
Once the connections have been completed (p. 17), turn on power to
your various devices in the order specified. By turning on devices in
the wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
Turning On the Power
1. To turn the power on, turn the [Volume] knob all the
way down, and then press the [Power ON] switch.
After the power comes on, the opening animation appears in
the screen within the music rest, followed by the Notation
screen.
After a few seconds, you will be able to play the keyboard to
produce sound.
fig.Power-e
2. Use the [Volume] knob to adjust the volume (refer to
the next section).
NOTE
This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate
normally.
Turning Off the Power
1.
Turn the [Volume] knob all the way down.
2.
Press the [Power ON] switch.
The screen display goes blank, and the power is turned off.
* If you need to turn off the power completely, first turn off the [Power
ON] switch, then unplug the power cord from the power outlet. Refer
to “Power Supply” (p. 9).
■ Adjusting the Volume of the Sound
1.
Turn the [Volume] knob to adjust the overall volume.
Adjust the volume level as you play the keyboard and listen to
the sound.
fig.MasterVolume-e
→ You can also adjust the headphone volume with the [Volume] knob.
1. To adjust the contrast of the screen, turn the [Contrast]
knob located at the back of the music rest.
fig.Contrast-e
Some Notes on Using the LCD Screen
• Never remove the liquid crystal display cover at the back of the
music rest. By removing it you risk electrical shock and/or
malfunction.
• You may see vertical lines in the screen, but this is due to the
structure of a liquid crystal display, and does not indicate a
malfunction. By using the [Contrast] knob to adjust the contrast
of the screen, you can minimize these lines.
• The contrast of the screen may be affected by the temperature.
Power ON
Adjusting the Contrast of
the Screen
Min Max
Rear of the Music Rest
Liquid Crystal Display Cover
HPi-6-e.book 18 ページ ２００５年１１月１５日 火曜日 午後３時４９分