Roland HPi-6 - Manual (Page 17)

17
Before You Begin Playing
■ Attaching the Music Rest
The music rest of the HPi-6 contains a liquid crystal display screen.
Use the following procedure, and handle the music rest with care.
1. Secure the music rest in place by turning the included
screws (at two points).
When attaching the music rest, support it firmly with one hand
to make sure that you don’t drop it. Be careful, so you don’t get
your fingers pinched.
fig.MusicRest
2. Connect the LCD cord of the music rest to the LCD Out
connector on the rear panel of the HPi-6.
NOTE
The power must be off when connecting the cable of the music rest.
fig.LCDCord-e
■ Using the Music Holders
You can use the holders to hold pages in place.
When not using the holders, leave them folded down.
fig.MusicHolders
■ Connecting the Pedal Cord
1. Insert the end of the pedal cord extending from the
piano stand to the Pedal jack located at the lower part
of the HPi-6’s rear panel.
fig.PedalCord
■ Connecting the Power Cord
1.
Insert the included power cord into the AC inlet
located on the rear bottom of the HPi-6, then plug the
other end of the cord into a AC outlet.
NOTE
Use only the included power cord.
fig.ACCord-e
Setting Up for Performing
Screw Screw
View from Rear
LCD Cord
Pedal Cord
AC In
Power Cord
AC Outlet
HPi-6-e.book 17 ページ ２００５年１１月１５日 火曜日 午後３時４９分