Roland Sonar V-Studio VS-700 - Manual (Page 28)

28
Turning the Power On
941
Once the connections have been completed (p. 26), turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers
and other devices.
945
If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from
the power outlet. Refer to “Power Supply” (p. 6).
1. Minimize the VS-700C’s [AUDIO OUTPUT]
knobs (three locations).
2. Start up your computer.
3. Turn on the power switch of the VS-700C.
4. Turn on the power switch of the VS-700R.
5. Turn on the power switch of your monitor speakers.
Due to a circuitry-protection feature, the VS-700R requires a few moments after power-up before it is ready
for normal operation. If the connections are correct, the VS-700R’s USB indicator will light.
VS-700C Top Panel
VS-700C Rear Panel
Power On
VS-700R Front Panel
Power On
If the USB indicator of the VS-700R I/O unit isn’t lit
If the USB indicator of the VS-700R isn’t lit, the driver has not been installed correctly. Refer to the
“Troubleshooting” chapter in “Getting Started.”
If the I/O indicator of the VS-700C console or the CONSOLE indicator of the VS-700R I/O unit is blinking
Check the following points.
• Are the VS-700C and VS-700R powered up?
• Are the VS-700C and VS-700R correctly connected via the dedicated cable?
• Is the VS-700 R I/O unit connected to your computer via a USB cable, and is the USB indicator of the
VS-700R I/O unit lit?
VS-700_r_e.book 28 ページ ２００８年１１月２０日 木曜日 午後２時２８分