Roland Sonar V-Studio VS-700 - Manual (Page 112)

112
Creating a Patch
F-Env T4 V-Sens
(TVF Envelope Time 4 Velocity Sensitivity)
The parameter to use when you want key release speed to
control the Time 4 value of the TVF envelope. If you want
Time 4 to be speeded up for quickly released notes, set this
parameter to a positive (+) value. If you want it to be slowed
down, set this to a negative (-) value.
Value: -63– +63
F-Env Time KF (TVF Envelope Time Keyfollow)
Use this setting if you want the TVA envelope times (Time 2–
Time 4) to be affected by the keyboard location. Based on the
TVF envelope times for the C4 key (center C), positive (+)
settings will cause notes higher than C4 to have increasingly
shorter times, and negative (-) settings will cause them to
have increasingly longer times. Larger settings will produce
greater change.
Value: -100, -90, -80, -70, -60, -50, -40, -30, -20, -10, 0,
+10, +20, +30, +40, +50, +60, +70, +80, +90, +100
fig.06-031.e
F-Env Time 1–4 (TVF Envelope Time 1–4) ★
Specify the TVF envelope times (Time 1–Time 4). Higher
settings will lengthen the time until the next cutoff frequency
level is reached. (For example, Time 2 is the time over which
Level 1 will change to Level 2.)
Value: 0–127
fig.06-037.e
F-Env Level 0–4 (TVF Envelope Level 0–4)
Specify the TVF envelope levels (Level 0–Level 4). These
settings specify how the cutoff frequency will change at each
point, relative to the standard cutoff frequency (the cutoff
frequency value specified in the TVF screen).
Value: 0–127
C4 C3 C2 C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
T1 T2 T3 T4
L3 L1
L0
L2 L4
Note off
Cutoff
Frequency
Time
Note on
T: Time L: Level
VS-700_r_e.book 112 ページ ２００８年１１月２０日 木曜日 午後２時２８分