Rear panel – Roland Sonar V-Studio VS-700 User Manual
Page 21
21
Panel Descriptions
O
v
er
vie
w
C
onnec
tions
V
S-700C C
onsole
V
S-700R I/O
F
a
n
tom V
S
A
p
pendix
fig.panel-vs-700r-rear.eps
A. TO CONSOLE Connector
Use the dedicated cable to connect this to the VS-700C console. Do not use any cable other than the dedicated cable.
➔
“Connecting Your Computer and Sound Reinforcement Equipment”
B. AC Inlet
Connect the included power cord to this inlet.
➔
* For details on the power supply and power consumption, refer to
C. MIDI IN Connector
This is a MIDI input connector. You can connect your MIDI keyboard or MIDI controller here. This can also be used as
an MTC input. In the driver, this will appear as “IO MIDI (VS-700).”
MIDI OUT Connector
This is a MIDI output connector. You can connect an external MIDI sound module here. In the driver, this will appear
as “IO MIDI (VS-700).”
D. USB Connector
Connect this to a computer that supports USB 2.0.
➔
“Connecting Your Computer and Sound Reinforcement Equipment”
At first, before connecting anything to this connector, you must install the driver as described in “Getting
Started” (separate document). After the driver has been installed and connections have been completed
correctly, the USB indicator will light. If the USB indicator isn’t lit, the driver has not been installed correctly.
Refer to the troubleshooting section of “Getting Started,” and install the driver once again.
Rear Panel
A
C
D
E
F
G
H
I
B
J
VS-700_r_e.book 21 ページ 2008年11月20日 木曜日 午後2時28分